Ramble on “Rosie”

2021 Sprinter 170″ Extended

Van Conversion

 

  • Insulation: Rubberized underlayment floor insulator and rigid insulation foam for the ceiling with mineral wool and 3 in 1 underlayment with vapor barrier insulation.
  • Paneling: 8″ shiplap walls and 6″ pine shiplap ceiling with fabric wrapped rear and sliding door pillars.
  • Floor: Wood grained laminate plank floor with Loncoin in the garage area and aluminum trim, partially enclosed step with cubby-great for shoes or dog leases.
  • Bed space:  Fixed loft-style bed platform with headboard with custom made bed hooks.
  • 6″ king sized memory foam firm, custom cut to fit the bed platform.
  • Two bench seats with storage with an added flip open doors for mini composting toilet use.
  • 4″ luxury high density foam dinette cushions with crypton fabric cushion covers.
  • Table with Lagun table mount with walnut top.
  • Standing closet with rod and lighted mirror mounted to door with drawers below.
  • 2 sectioned pull out pantry with control panel above.
  • True Induction TI-1B Single Burner Energy Efficient Induction Cooktop that is removable from cooktop drawer.
  • Brushed 430 stainless steel magnetic backsplash with custom mountain etching.
  • Kraus Bolden stainless steel commercial pull-down sprayer faucet and Undermount stainless steel sink
  • Isotherm DR 85 Inox Stainless Steel Drawer Refrigerator
  • Black and Decker microwave.
  • 30 gallon fresh water tank mounted in garage space with water pump, water pump shut off and a tank monitor with custom stainless etching.
  • 5 gallon gray water jug underneath sink.
  • 4 gallon electric water heater.
  • Outdoor shower quick release attachment to water tank and a Quick release hose attachment to water tank with high pressure pump.
  • Pull out gear tray with 500lb strength drawer slides.
  • Bungee nets for lower rear door storage for added storage.
  • Strip lights in garage storage area
  • 10 interior ceiling puck lights with dimmable switches.
  • Set of reading lights for bed platform.
  • RGB LED Strip lights mounted to trim above bed to illuminate ceiling
  • SensorPush Wireless Thermometer and SensorPush G1 WiFi/Ethernet Gateway
  • Maxxair 10 speed fan with waterproof shroud.
  • Floor mount air filter to bring in cool, filtered air front underneath van, and better circulate air within van.
  • Webasto diesel cabin heater mounted underneath passenger side seat.
  • Nomadic Cooling 3000 12V Roof mount system
  • CRL T-vent windows for sliding door and driver’s side front panel.
  • 300 amp hour LiFePO4 lithium battery bank with built in battery management system, connected to alternator with battery separator; master disconnect switch.
  • 3000 watt pure sine AIMS inverter.
  • 60 amp battery charger with 15 amp plug in.
  • (2) 60 cell solar panels, Victron solar charge controller, and Victron smart solar battery monitor.
  • We Boost LTE booster.
  • Bose Smart 300 sound bar with subwoofer
  • Custom roof rack with Highbeam light mounted to roof rack and switched at dash.
  • LED reverse lights mounted to roof rack and integrated with factory reverse lights and switched at dash.
  • Fiamma mechanical F80S awning.
  • Driver and passenger side electric steps
  • Owl Vans rear door tire carrier and sherpa rack.
  • CA tuned Hammerhead front bumper w/ Grey D-Rings and a Smittybilt X2O GEN3 12K Winch with Synthetic Rope
  • PIAA Super Bass Horn Upgrade
  • Rocker Panels and hood Vinyl Wrap
  • Passenger and driver side custom welded low clearance step.
  • Flush L-track mounted to ceiling for attachment point of hammock mounts.
  • Vinyl wrap for hood and rocker panels.
  • 49 gallon replacement fuel tank.
  • Van Compass Stage 5 system with 2″ lift with Agile spring kit and Hellwig Heavy Duty Rear Sway Bar
  • Alpine Mechanisms Driver and Passenger Swivel Seat Base
  • Custom frame of a Pohl Print.

Check out our other conversions in our project gallery.

Stay updated with our Facebook pagePinterest page, and Instagram page!

Have questions? Reach out to us!